List of products by brand Protec

Branch boxes, with clamps Material: polypropylene, fiberglass reinforced. Sealing: thermoplastic elastomer. Housing of two components (robusted housing and elastic insertion membranes). Flame retardant according to EN 60695-2-11. Halogen-free. Impact resistant and UV resistant type 308, 407 and 607 integrated thread (no counter nut required). Type 407, 607 and 1010. Chemical resistance: resistant to alkalis and inorganic acids, seawater. Voltage cracking: low. Temperature resistance: -30°C to +100°C, short to approx. Installation temperature: -5°C to +60°C. Incandescent wire test: 750°C. Colour: grey. Mounting options: Through 4 internal openings outside the sealing area or with type 308 and 407 with quick mounting bracket. 4 unreleasable lid screws. Screw clamps 5-pin. Type 308: Clamp 2.5 mm2, cable insert 8 side, membrane insert, 400 W Type 407: Clamp 4.0 mm2, cable insert 7 side +2 in the bottom, membrane insert, 690 W Type 607: Clamp 6 mm2, cable insert 7 side +3 in the bottom, membrane insert, 690 W Type 1010: Clamp 10mm2, cable insert 10 side +2 in the bottom, with gasket, 690 W14. Protection type: IP 66; IP 67 with screw connections. In the case of design protection IP 66 - sweat water formation possible. By using casting gel or pressure compensation cable screw connections which serve to reduce condensation water, a condensation water formation can be strongly limited and the protection class IP 66 is maintained. Condensation water openings are present at the rear, the protection is reduced when punched out. Minimum order quantity: 1 piece External dimensions: 85x85x51 mm For cable Ø: 3-12 mm / M20 Max. Conductor cross section: 4.0 mm2

Screw box assortment Device/Decleaning Screws 15, 25 and 40 mm, Ã ̃ 3.2 mm, capacity in each case 100 pieces, self-tapping thread, corrosion-resistant, bit size Slot design: slot depth: 0.8 mm + tolerance range: 0.2 mm, slot width: 0.8 mm + tolerance range: 0.2 mm, bit size: 1x50 mm or as smallest size 0,6x45mm, bit size cross design: Philips Size 1 Number of screws: 300

Hot-shrink connection fittings 0,6/1 kw (1,2kV) For 4- and 5-core plastic-insulated cables, made of high-quality crosslinked polyofin, shrinkage rate 4:1, continuous use temperature -40°C to +120°C, non-corrosive and cadmium-free, color: black, delivery length: 400 mm cable up to mm2: 5 x 1.5/5 x 16 sleeve length: 400 mm

Incl. Suitable for copper and aluminum conductors, application areas: interior, open air, soil, water and installation equipment etc. Longitudinal and crosswater sealing, good mechanical strength, high-quality transparent, impact-resistant plastic mould shells, immediately ready to use, without cable connectors. Curing time: about 24 hours depending on the outside temperature. Power supply can be switched on immediately after installation of the socket (not to be taken into account). Cable up to mm2: 4 x 50 cable Ø: 21 - 43 mm casting resin: 650 ml

Afterrunning relays can be selected in 3-minute steps, on/off switchable start-up delay, can be coupled with room lighting or with pushbutton/switch, can be used with control cabling 3 x 1.5 mm2, switching power: 0.8/4A, follow-up time: 3-24 minutes, start-up delay: 0/2 minutes, reaction time: 0.3 sec, due to its small construction it fits into any commercial distribution box

Insulation tapes Flame retardant, ozone and abrasion resistant, ageing and weathering resistant, WDE tested Length: 25 m Width: 19 mm Colour: black Insulation: Yes

Special holding spring made of metal. To use D01 fuses in K02 and D02 fuses in K02 or K03 screw caps

Signier chalk 1 VE = 12 pieces Version: chalk blue

For laying electrical, telephone and antenna cables in pipe systems by means of sliding glass fiber profiles and various guide heads, maximum tensile load: 100 kg, set contains:3 mm glass fiber profile, 2 front sleeves, 3 guide heads (diameter: 8, 11, 14 mm,) 2 connecting sleeves (for repair handle) 2 pull-in sleeves, 2 cable pull-in stockings (4 seconds - 6 mm)

Fiber Optic Replacement Tape For PKE cable draw-in and PKES cable draw-in system for cable draw-in set: 05101634 Length: 30 m

Cable Knife with Wooden Handle Wooden Handle two-part design: 1part blade shape: straight With scraper: Yes Foldable: Yes

Plastic material housing with metal blade guide,Cutter 140 mm incl. 1 blade cutter 170 mm incl. 3 blades (1 mounted + 2 blades in the magazine) Version: Replacement blades Length of blade: 170 mm