Eltako FBH65S-wg Motion brightness sensor

Radio motion brightness sensor for ceiling mounting, the radio motion brightness sensor FBH, supplied with a solar module, sends a message into the ELTAKO radio motion brightness sensor for splash mounting 84x84x39mm or assembly into the E-design switch system. Power supply with the integrated solar cell or with a 12VDC power supply or with batteries. In the delivery state, the energy store is empty and must be charged before commissioning. Either via the red-black 12W DC connection cable in approx. 3 minutes or via the solar cell in bright daylight approx. 10 hours or by inserting two AAA batteries (not included) in about 10 minutes. In normal operation, the power supply takes place either via the connection cable with a 12W DC switching power supply FSNT61-12V/6W in an UP-dose under the sensor or with AAA batteries, supported by the solar cell, or only with the solar cell with normal ambient brightness, in the daily average at least 200 lux. If only the solar cell is available, the energy store must be charged several days with daylight. If the connection cable is not required, it can be cut off. As a result, the sensor does not require any installation depth behind the holding plate and can be screwed onto any flat surface. For screwing on, the complete module can be pulled out of the frame. 2 pieces stainless steel counter screws 2.9x25mm and 5x25mm dowels are included. For learning into an actuator located in the learning mode, the adjacent blue or any other available magnet is held to the side wall below the point of the sensor marked with a rectangle. This sends a learning message. A red LED behind the Fresnel lens confirms the transmission of the learning telegram by short flashing. The sensor measures from 0 to 2000 Lux and sends every 100 seconds at a brightness change of at least. 10 Lux a Meldu