Eltako FAM14 Radio antenna module

Radio antenna module for mounting on support rail DIN-EN 60715 TH35, forwards all radio signals addressed to downstream radio actuators in its receiving area, mini-USB for connecting a PC for creating a device list, for configuring the actuators using the PCT14 PC tool and for data backup, supply voltage 12V DC radio antenna module for the Eltako-RS485 bus with interchangeable antenna. With integrated power supply 12V DC/8W. Bidirectional. Encrypted radio. Stand-by-loss only 1 watt. If required, a radio antenna FA250 or FA200 can be connected. Row mounting device for mounting on support rail. 36mm wide, 58mm deep. Supply voltage 230V. Included are 2 terminal resistors for mounting with imprint, 1/2 TE, 3 plug-in bridges 1 TE (including 1 replacement), 2 plug-in bridges 1/2 TE (including 1 replacement) and a plug-in bridge mounting tool SMW14. The radio antenna module FAM14 receives and checks all signals from the radio transmitters and repeaters in its reception area. These are passed through an RS485 interface to downstream RS485 bus switch actuators: Up to 126 channels can be connected to the RS485 bus. Bus and power supply with plug-in bridge. At the last actuator, the adjacent second terminal resistor must be plugged on. Up to 128 encrypted sensors can be learned. Mini USB to connect a PC to create a device list, to configure the actuators using PCT14 and to backup data. A legalization code for downloading the PCT14 from the Eltako-Homepage www.eltako.de is attached to FAM14. With a load greater than 50% of the rated power of 8W, half a division unit is required for ventilation with the spacer DS14 on the left side. TLE: 2 radio frequency: 868 MHz