List of products by brand Berker

Blind closure with central piece and screw fastening Berker B.3/B.7 anthraciteOn support plate with large cutout, with cover plug for screwing, without spreader claws, for individual cutouts or bores when installing special solutions, space-saving for e.g. relays

central piece with regulating knob for speed control Berker S.1/B.3/B.7 polar white,central piece with regulating knob for speed control Berker S.1/B.3/B.7 polar white, shiny - axis diameter 4 mm - with imprint symbol Schweif

floor temperature controller with lock, central piece, wipp switch, Berker S1 / Bfloor temperature controller with lock, central piece, windscreen switch, 2 LED and floor temperature sensor Berker S.1/B.3/B.7 white, shiny - with imprint - regulating knob with temperature range limitation - with in/off switch and 2 LED - with LED for heating and LED for night reduction - with separate connection for night reduction - for example for adjusting drives closed without current - without spreading claws - with plug clamps 10 - 50 °C, 50/60 Hz nominal voltage 250 V~ switching current 10. 1 °C night reduction approx. 5 °C Sensor line length 4 m neutral conductor required! If the temperature is below, the contact closes.

plaster case 1x Berker S.1 polar white, mattIntroduction above and below possible, suitable for installation on flame-resistant substrate, installation depth 37 mm

Blind series switch 1-pole with imprint Symbol arrows AP Berker W.1 grey/liwith cable entry for 2 cables and cable entry for cable or pipeAP

IP55Nennial voltage: 250 V ACRated current: 16 AOperating temperature: -40/60 °CConnection terminals: according to VDE 0620-1with full-surface seal on the rear side of the housing for rear line introduction and cleaning compensation with falling flap cover, manually lockable with 2 snap-in places for Wago 2-wire connection clamps in housing bottom with Wago 2-wire connection terminal for horizontal mounting 2 additional lateral line introductions with an introduction for 2 lines and an introduction for pipe or pipe Wired inserts with connectors Due to the lateral line introductions, particularly suitable for mounting via work benches. Stainless steel hinged cover springs, pins of the ZAMAK quick release. grey/light grey matt 4 line introductions
AP

socket SCHUKO 3 times horizontal with hinged lid AP Berker W.1 grey/light grey m
pre-wired, with cable entry for 2 cables and cable entry for cable or pipe, stainless steel housing screws, with Wago 2-wire connection terminal, additional Wago 2-wire connecting terminal lockable.

Rated voltage: 250 V ACSwitching current: 10 AXOperating temperature: -40/60 °C lens with full-surface seal on the rear side of the housing for rear line introduction and cleaning compensation with 2 snap-in places for Wago 2-wire connection clamps in housing bottom with Wago 2-wire connection terminal with {b rotem} LED Aggregat 230 V for control circuit with an introduction for 2 lines and an introduction for pipe or pipe with connectors with N-terminal ZAMAK quick release pins.

probe dimmer (R, L); Electronic platform 2012; lower own energy requirements; switch-on brightness can be stored reliably; soft start; Phase cut; short-circuit-resistant and overload-proof (electronic fuse); with auxiliary point input for pushbutton (closer) with single-surface operation and motion detector; also suitable for Fit matching KNX radio attachments; expandable by Universal performance add-ons Plus REG; no conductive connection between support ring and Expanding claws; with screw clamps.Operating voltage: 230 V~Frequency: 50/60 HzPower consumption (standby): 230 V bulbs and halogen lamps: 25 ... 400 Wdimmable, conventional transformers: 25 ... 400 VAOperating temperature: -5 ... +45 °CNumber of auxiliary points: unlimitedLine length side points: max. 50 mLoad line length: max. 100 mScrew terminals: max. 1 x 4 / 2 x 2,5 mm2Installation depth: 32 mm

Frame 4x Q.1 polar white, velvet. Cover frame for vertical and horizontal mounting. For use of polar white central pieces. Underput installation, area program, 4-fold. Material: plastic, thermoset, halogen-free. Cover frame for vertical and horizontal mounting. For use of polar white central pieces. Underput installation, area program, 4-fold. Material: plastic, thermoset, halogen-free.

Wippen mit Aufdruck Symbol arrow Q.1/Q.3 polarwhite, velvet. Wippen mit Aufdruck Symbol - Arrow -. For blinds/stop switches and buttons-BA 2-fold. Underput installation, area program. Material: plastic, thermoset, halogen-free. Wippen mit Aufdruck Symbol - Arrow -. For blinds/stop switches and buttons-BA 2-fold. Underput installation, area program. Material: plastic, thermoset, halogen-free.

rocker screwable Berker S.1/B.3/B.7 polar white, mattrocker screwable Berker S.1/B.3/B.7 polar white, matt - with cover plug for screw connection - for flip-flop switch off/change, cross - for flip-flop